By logging in you:

  • Buy at cheaper prices

    The page you requested was not found.

    • If you typed the URL directly, please make sure the spelling is correct.
    • If you clicked on a link to get here, the link is outdated.

    You can select one of the following actions:

    • Go back to the previous page.
    • Use the search bar at the top of the page to search for your products.
    • Follow these links to get you back on track:  Home | My Account
  • Get discount coupons

    The page you requested was not found.

    • If you typed the URL directly, please make sure the spelling is correct.
    • If you clicked on a link to get here, the link is outdated.

    You can select one of the following actions:

    • Go back to the previous page.
    • Use the search bar at the top of the page to search for your products.
    • Follow these links to get you back on track:  Home | My Account
  • You don't have to fill in your name, address etc. (at any future orders)
  • You may track your order online at any time

Clay Court Lines Geniala 5cm

(full set)

SKU: TOTLSG5

was €500.00 Special Price €409.90
Clay court lines Geniala are ideal for all types of clay courts. They can be easily attached on the court with stainless steel anchors into the sleeves embedded into the court. They are supplied in the precise length of each tennis court line.
Share

Each set will be shipped with 6 layouts for a double court. To protect the lines we will also ship an end fixation. An introduction with pictures will be shipped too.

ASSEMBLY INSTRUCTIONS

Warning:. Always start from the basic line!

1) Measure the pitch and mark the outer corners according to the attached diagram.

2) Mark the point to attach the steel anchor for basic line.

3) Use the hammer to attach the steel anchor into the ground.

4) The anchor has to be directed as on the picture.

5) Put the anchor about 2 cm below the surface level.

6) Remove the clay around the ending of anchor.

7) The upper part of anchor has to be free about 2 cm.

8) Expend the selected line in the direction of installation (between installed anchors)

9) The anchor plate put on the ending of anchor.

10) Use the hammer to attach the anchor plate.

11) The plate should be flat with the clay surface.

12) Move the line about 1 part between the lines, to exceed the point (line) that will be cut off after installation.

13) Use the same principle (points 9 - 12) for the other ending of line.

14) Put the tensioning device (hook) into the cross section of the line and drag the line by 1 - 2 pieces over point that will be cut off.

15) Hold the tightened line at the center of its length, lift it slightly, and then let it fall again. The line is ideally aligned equally.

16) Carefully step through the line and then enter it into the pitch. Work carefully to prevent the damage of lines.

17) Cut the lines to the specified and prescribed lengths.

18) Example of anchor positioning and setting at the crossing point.

19) Stage before line insertion and tensioning.

20) Crossing T – detail of anchor assembly.

21) Crossing T - crossing in the middle of the pitch.

22) Montage T - crossing, by hand, you need to slide the line up to 1 part between the cutouts to the point in which the line will be cut after stretching.

23) Montage T - crossing, use the tensioning device.

24) Precisely cut the lines at all points.

25) Below the ends of the lines you need to add enough clay for a perfect fit.

26) It is good to use the clay with water.

27) The line can be easily detached due to screwdriver.

28) The line can be also released due to screwdriver while holding in your hands.

29) The line can be easily attached to a buckle again.

Warning: It is necessary to roll the surface in the same direction of the lines! Roll 2 - 3 m to the front and about 50 cm back. More intense rolling would adversely affect line tension.

More Information
Brand by Sport Topspin tennis
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account